Take your creativity to the next level with Floriani’s NEW single side fusible fleece! Home Dec Fleece – Single Fusible features our versatile low melt fusible coating on one side of our light weight fleece. This allows you to fuse the fabric to the front (or back) with NO pinning! Because it is needle punched, this fleece is ideal for quilted or heavily embellished wall hangings and the light loft eliminates unwanted bulk. Be sure to try Home Dec Fleece – Single Fusible for your next quilted bag, table-runner, decorative pillow lining, place-mats and more! |
Directions for Use:
Because this product has a fusible coating on one side, it is essential to be aware of which side is fusible and protect your iron by using a pressing cloth or heat resistant Teflon pressing sheet or parchment paper.
Smooth the fabric with wrong side to the shiny (fusible) surface of the fleece. Have your iron heated to medium and then press down firmly on the fabric (using the continuous steam feature is ideal). Be sure your iron touches the fabric only, NOT the fleece. Use a press cloth/sheet to protect your iron if needed. **It may be necessary to hold the iron in place for several seconds to achieve a good bond. Repeat this process until all areas have been fused.
**Just like traditional quilt batting, it is also recommended to cut Home Dec Fleece – Single Fusible at least one inch larger than your fabric piece and then trim to size after it is fused into place.
**Because all irons vary in temperature settings, start at a lower setting and gradually increase the heat setting until you get a good fuse. It is important to test your iron and settings on a scrap of fabric before beginning your project.
This product is washer/dryer friendly but should be tested before using within your project.
Sizes available:
60” x 15 yards, 60” x 5 yards or 60” x 1 yard |
