Experience sheer, soft and non-stretch stability with this ultra-light-weight cutaway. The temporary fusible coating creates a necessary bond to prevent fabrics from stretching or distorting. Use for stabilizing T-Shirt Quilts, bias cut pieces or simply to keep blocks from moving while adding sashing or borders. Another use for this super soft stabilizer is to create flawless turned edge applique with sealed edges – check out our project web page to learn this super technique! |
|
Directions for Use and Care
For stabilizing a T-shirt quilt block:
- Cut Select Cutaway at least one inch larger than the T-shirt block.
- Place the fusible side of Select Cutaway to the wrong side of the block.
- Cover the Select Cutaway with a pressing cloth or piece of cotton.
- Press using a medium iron temperature (wool).
- Square the block by trimming away the excess Cutaway.
For stabilizing embroidery on knit:
- Cut Select Cutaway at least one inch larger than the size of the embroidery frame intended for use.
- Place the fusible side of Select Cutaway to the wrong side of the fabric or garment. *If the design is dense or large, place a second layer at a 45 degree angle, directly over the first piece.
- Cover the Select Cutaway with a pressing cloth or piece of cotton.
- Press using a medium iron temperature (wool).
- Place the now stabilized fabric within the hoop and stitch.
- Once the embroidery is complete, pull the stabilizer back to the design and trim away the excess. It may be necessary to reheat the stabilizer in order for it to release from the fabric.
Washer and Dryer Safe
Cool water and low drying temperature recommended.
Press using a low to medium setting on your iron and press cloth. Do not touch the iron directly to the stabilizer. |
|
Size Available
|
QSC-1510 |
15½ x 10 yards (38.1 cm x 9.14 m)
|
|
Select Cutaway Resources
(PDF reader required)
|
![Quilters Select Cutaway by Alex Anderson](graphics/qs/select-cutaway.jpg) |
![Quilters Select Cutaway by Alex Anderson](graphics/qs/select-cutaway-1.jpg) |